KOMP'YUTERNOE MODELIROVANIE PROCESSA IZGOTOVLENIYA IZDELIYA «LOPATKA» IZ PLASTMASS LIT'EM POD DAVLENIEM
Authors:
1.
KNITU
2.
KNITU
3.
KNITU
4.
KNITU
Type:
Article
eLocation:
Status:
Published
Received:
19.04.2023
Accepted:
01.08.2025
Published:
01.08.2025
Subject area:
UDC 678.5
Language:
Russian
Keywords:
Компьютерный анализ, процесс изготовления изделий литьем под давлением, Computer analysis of the process of manufacturing products by injection molding
Abstract (English):
A computer analysis of the process of making an article "blade" molding with the use of Autodesk Moldflow Insight 2012. Influence main process parameters (injection time, melt and mold temperature, supply pressure) on the properties of the molded products when used for making various polymers of two grades of polypropylene, polyethylene and high impact polystyrene. Based on the findings recommendations for getting the best quality products.
A computer analysis of the process of making an article "blade" molding with the use of Autodesk Moldflow Insight 2012. Influence main process parameters (injection time, melt and mold temperature, supply pressure) on the properties of the molded products when used for making various polymers of two grades of polypropylene, polyethylene and high impact polystyrene. Based on the findings recommendations for getting the best quality products.
Keywords:
Компьютерный анализ, процесс изготовления изделий литьем под давлением, Computer analysis of the process of manufacturing products by injection molding
Компьютерный анализ, процесс изготовления изделий литьем под давлением, Computer analysis of the process of manufacturing products by injection molding
1. Kurnosov V.V. Komp'yuternoe modelirovanie processa izgotovleniya izdeliy iz plastmass lit'em pod davleniem. / Kurnosov V.V., Peruhin Yu.V., Stoyanov O.V. // Vestnik Kazan. tehnol. un-ta. 2012.№14. S. 111-114.
2. Autodesk Moldflow Insight 2012 Beta. What’s new in this release. Autodesk, Inc., 2010. - 20 p.
