The article presents research on replacement of elastomeric materials in the DTEP to traditional thermoset rubbers. The method allows to obtain high-performance materials with improved balance of performance properties of the specific impact strength, frost resistance, melt flow, the ability to process by injection molding.
обратимая деформация, пластификатор, экструзия, физико-механические характеристики, удельная ударная вязкость, reversible deformation, plasticizer, extrusion, stress-strain properties, specific impact viscosity
1. Pererabotka plastmass: spravochnoe posobie / pod red. V.A. Braginskogo. - L.: Himiya, 1985. -296 s.
2. Ermakov S.N. Himicheskaya modifikaciya i smeshenie polimerov pri reakcionnoy ekstruzii / S.N. Ermakov, M.L. Kerber, T.P. Kravchenko // Plast. massy. - 2007. - № 10. - S. 25-29.
3. Mahlis F.A. Tehnologicheskiy spravochnik po rezine / F.A. Mahlis, D.L. Fedyukin. - M.: Himiya, 1989. - 400 s.
4. Kanauzova A.A. Poluchenie termoplastichnyh rezin metodom «Dinamicheskoy vulkanizacii» i ih svoystva: Tem. obzor / A.A. Kanauzova, M.A. Yumashev, A.A. Doncov. - M.: CNIITEneftehim, 1985. - 69 s.
5. Garifullin R.Sh., Bazotov V.Ya., Sal'nikov A.S., Fayzullina M.R., Ahmadiev I.D., Borisov V.M., Vestnik Kazanskogo tehnologicheskogo universiteta, 16, 2, 67-69 (2013).
6. Yu.A.Kovalenko, G.I.Garipova, A.M.Nigmetzyanova, Vestnik Kazanskogo tehnologicheskogo universiteta, 15, 18, 150-153 (2012).
