It is presents the results of solving the optimization problem of effective preparation foundry models of the chemical and petrochemical equipment, produced by casting in sand and clay molds by developing 3D-models and their subsequent printing on 3D-printer.
модель для литейного производства, 3D-модель, 3D-принтер, foundry model, 3D-model, 3D-printer
1. I.S. Shulyak. Lit'e po gazificiruemym modelyam. NPO «Professional», SPb., 2007. 408 s.
2. V.M. Grigor'ev. Lit'e po vyzhigaemym modelyam. Izd-vo Habar. gos. tehn. un-ta, Habarovsk, 2002. 58 s.
3. S.A. Rybakov, Liteyschik Rossii. 4, 45-46 (2009).
4. V.S. Doroshenko, Liteynoe proizvodstvo, 9, 28-32 (2008).
5. V.S. Doroshenko, I.O. Shinskiy, K.H. Berdyev, Processy lit'ya, 3, 45-47, (2009).
6. V.P. Monastyrskiy. Liteynoe proizvodstvo, 9, 29-34, (2007).
7. A.A. Kurbangaleev, F.H. Tazyukov, G.N. Lutfullina, Yu.M. Danilov, Vestnik Kazanskogo tehnologicheskogo universiteta, 21, 261-264 (2013).
8. A.A. Homenko, I.I. Ponikarov, V.V. Kalinkin, Vestnik Kazanskogo tehnologicheskogo universiteta, 9, 191-193 (2012).
9. I.A. Sabanaev, F.M. Almakaeva, Z.F. Sabanaeva, Vestnik Kazanskogo tehnologicheskogo universiteta, 15, 315 - 318 (2013).
