ANALIZ FIZIKO-MEHANICHESKIH SVOYSTV METALLOREZHUSCHEGO I OBRABATYVAYUSCHEGO INSTRUMENTA PRI OBRABOTKE VCH PLAZMOY PONIZHENNOGO DAVLENIYA
Authors:
1.
KNITU; KNRTU
2.
KNITU; KNRTU
3.
KNITU; KNRTU
4.
KNITU; KNRTU
Type:
Article
eLocation:
Status:
Published
Received:
20.04.2023
Accepted:
01.08.2025
Published:
01.08.2025
Subject area:
UDC 537.525.7:621.762
Language:
Russian
Keywords:
ВЧ плазма, пониженное давление, сверло, дисковая фреза, угловая фреза, торцевая фреза, RF plasma, low pressure, drill, disc cutter, corner cutter, end mill
Abstract (English):
Method of hardening of cutting tools is considered. Coating on the surface of high-speed steel obtained by the RF plasma of low pressure. As a result of forming of a coating on the surface improvement of physical and mechanical properties of metals and increase of hardness was produced.
Method of hardening of cutting tools is considered. Coating on the surface of high-speed steel obtained by the RF plasma of low pressure. As a result of forming of a coating on the surface improvement of physical and mechanical properties of metals and increase of hardness was produced.
Keywords:
ВЧ плазма, пониженное давление, сверло, дисковая фреза, угловая фреза, торцевая фреза, RF plasma, low pressure, drill, disc cutter, corner cutter, end mill
ВЧ плазма, пониженное давление, сверло, дисковая фреза, угловая фреза, торцевая фреза, RF plasma, low pressure, drill, disc cutter, corner cutter, end mill
1. V.V. Savich, Konstrukcii iz kompozicionnyh materialov, 4, 114 - 119 (2006).
2. Hubathuzin A. A. Povyshenie tverdosti fiziko-mehanicheskih svoystv metallov i ih splavov s pomosch'yu VCh-plazmy ponizhennogo davleniya / A. A. Hubathuzin, I. Sh. Abdullin, V.I. Hristolyubova // Vestnik Kazanskogo Tehnologicheskogo Universiteta. - 2013. - T. 16; №23. - S. 25-28.
3. Hubathuzin A. A. Osobennosti izmereniya fiziko-mehanicheskih svoystv nanopokrytiy / A. A. Hubathuzin, I. Sh. Abdullin, V.I. Hristolyubova, S. V. Prokudin // Vestn. Kaz. Tehnologicheskogo Universiteta. - 2014. - T. 17; №2. - S. 39-42.
