ELEKTROFIZICHESKIE METODY OBRABOTKI UGLERODISTOY INSTRUMENTAL'NOY STALI U8
Authors:
1.
KNITU; KNRTU
2.
KNITU; KNRTU
3.
KNITU; KNRTU
4.
KNITU; KNRTU
Type:
Article
eLocation:
Status:
Published
Received:
20.04.2023
Accepted:
01.08.2025
Published:
01.08.2025
Subject area:
UDC 537.525.7:621.762
Language:
Russian
Keywords:
ВЧ плазма, пониженное давление, инструментальная сталь, RF plasma, low pressure, tool steel
Abstract (English):
Methods of hardening of metals are considered. The analysis and comparison of the considered methods is carried out. The covering on a surface of a tool steel by means of magnetron sputtering, NNV and RF plasma of lowered pressure is received. As a result of covering formation on a surface improvement of physical and mechanical properties of metals and hardness increase is received.
Methods of hardening of metals are considered. The analysis and comparison of the considered methods is carried out. The covering on a surface of a tool steel by means of magnetron sputtering, NNV and RF plasma of lowered pressure is received. As a result of covering formation on a surface improvement of physical and mechanical properties of metals and hardness increase is received.
Keywords:
ВЧ плазма, пониженное давление, инструментальная сталь, RF plasma, low pressure, tool steel
ВЧ плазма, пониженное давление, инструментальная сталь, RF plasma, low pressure, tool steel
1. V.V. Savich, Konstrukcii iz kompozicionnyh materialov, 4, 114 - 119 (2006).
2. I.Sh. Abdullin, A.A. Hubathuzin, Vestnik Kazan. tehnol. un-ta, 11; 625 - 627 (2010).
3. Hubathuzin A. A. Povyshenie tverdosti fiziko-mehanicheskih svoystv metallov i ih splavov s pomosch'yu VCh-plazmy ponizhennogo davleniya / A. A. Hubathuzin, I. Sh. Abdullin, V.I. Hristolyubova // Vestnik Kazan. tehnol. un-ta. - 2013. - T. 16; №23. - S. 25-28.
4. Hubathuzin A. A. Osobennosti izmereniya fiziko-mehanicheskih svoystv nanopokrytiy / A. A. Hubathuzin, I. Sh. Abdullin, V.I. Hristolyubova, S. V. Prokudin // Vestnik Kazan. tehnol. un-ta. - 2014. - T. 17; №2. - S. 39-42.
